KPC KL 310-3V Séries Manuel D'utilisation Et D'entretien page 21

Motobineuse
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

IDENTIFICATION AND TECHNICAL SPECIFICATIONS
ATTENTION: FOR THE ENGINE TECHNICAL SPECIFICATIONS, SEE THE ENCLOSED OWNER'S MANUAL OF THE ENGINE.
Acoustic power level LwA = from 92 dB (A) to 105 dB (A)
Noise level at operator's ear : LpA = from 81 dB (A) to 90 dB (A)
Test condition: 1,6 mt at the centre of the handlebar
Handlebar vibration according to ISO 1033: value from 4,76 m/sec² to 7,00 m/sec²
CHARACTERISTICS OF ALL THE ENGINES FITTED:
Exhaust guard
Recoil starter
ENGINE LUBRICATION: see the owner's manual of the engine
Engine oil quantity: see the owner's manual of the engine
Engine fuel: unleaded petrol
Safety device for both forward and backward gear stopping the tiller.
The gear has got two forward speeds and one reverse, a belt joins the transmission to the engine and an oiled chain to the tiller.
SPECIFICATIONS WITH ENGINE RUNNING AT 3200 RPM
I forward = 82 rpm
II forward = 113 rpm
Reverse = 61 rpm
Speed gear in oil bath
Belt clutch with tightener
Tiller with hexagonal shaft and reinforced blades
Guidance handlebars can be adjusted in many positions (vertical and side adjustment).
The tiller is 80 cm wide.
The spur is adjustable
APPLICABLE ACCESSORIES
Ridger with attachment
Thin iron wheels (Ø 320) are suitable when using the ridger
CE MARK
To identify the machine (serial number, engine, weight, power) have a look at the number plate put on the machine as in (Picture 1 Ref. "A").
TILLING UNITS:
The blades are adjustable and provided with a protection mudguard. In picture number 2 you can see the possible working width: 60 – 80 cm with
the extensions and the side plates fitted.
DIMENSIONS
The dimensions of the tiller are shown in picture 3.
KL 310-3V
21

Publicité

Table des Matières
loading

Table des Matières