Eneo VKC-1327C/W3 Guide D'installation Rapide page 15

Make sure the power is removed before installation.
Connection (Easy installation) at the cable end
1. The cover cap serves to protect against dirt during the installation (e.g.
when the cable is led through a wall).
2. The attached shrink tube serves to protect the connection.
To use this, cut off a suitable amount, push it over the connection and
shrink it.
Installation on Wall
1. Loosen three ⑩ neck fastening screws a little (but not completely) so
that camera body can move.
2. Secure the ⑫ mount base with screws supplied to the wall or cei-
ling. Make sure that the cable is routed safely not to be damaged by the
⑫mount base (see gap).
3. Separate the ① housing body by loosening two ⑧ rear cover screws
and place it at a safe area. Make sure that inside of the ① housing body
should not be contaminated by dust or liquid
All manuals and user guides at all-guides.com
Installation
DE
EN
FR
PL
RU
15