Tripp-Lite DWT1327S Instructions D'installation page 4

1. Disassemble VESA Plate
2a. Mount on Wood Stud Wall
• Make sure that mounting screws are anchored into the center of the studs.
Use of a stud finder is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
14-03-251-933335.indb 4
All manuals and user guides at all-guides.com
Anchor Bolt
5mm-8mm
WARNING
4
Loosen the top screw with a
screwdriver to separate the VESA
plate from the wall mount.
1
Find and mark the
exact location of
mounting holes
Maintain a 5mm-8mm
space between the wall
plate and anchor bolt.
2
3
Drill pilot holes
Screw the wall
mount onto
the wall
4/14/2014 1:59:26 PM