Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTION
Schematic illustration
slide hammer
1. Chose suitable puller bolt. The size has to be chosen in accordance to the internal diameter of
the bearing to be pulled.
2. Push the puller bolt through the cone of the bearing so that the pulling edge of the bolt grabs
behind the cone.
3. Adjust the diameter of the puller bolt to the internal diameter of the bearing by tightening the
puller screw.
4. Mount slide hammer onto the adaptor screw and pull out the bearing by operating the glide
hammer carefully.
or...
5. Mount two-arm puller onto the adaptor screw and pull out the bearing by twisting the two-arm
puller.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
puller and adaptor
screw
bearing
body
puller bolt
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
two-arm puller
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicité
