Publicité
Les langues disponibles
Les langues disponibles
2. Position the machine's rear stand
on the rear stabiliser bar (47), as
shown in Fig.1, insert the bolts (49), fit
the flat washers (48) and then tighten
securely.
3. Position the front stabiliser bar with
wheels (81), paying attention to the
red dots and with the wheels facing
forwards, as shown in Fig.1, insert the
bolts (48), fit the flat washers (49) and
tighten securely.
2.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (37R), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely,
Fig.1.
The left-hand pedal, marked with the
letter (37L), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.1.
3.- ATTACHING THE SADDLE.-
Insert the seat stem (21) into the hole
on the main body, Fig.3. Fit the saddle
bracket (16), Fig.3, onto the horizontal
saddle tube (21), as shown in Fig.3, fit
the saddle into position and tighten the
nuts on the bracket securely.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob
(20)
slightly
anticlockwise, Fig.2, move the saddle
direction.
Tighten
by
turning
to a position comfortable for doing
exercise
adjustment knob (20) securely by
turning it clockwise.
HORIZONTAL ADJUSTMENT OF
THE SADDLE.-
Loosen the knob (20) slightly by
turning it anticlockwise, Fig.3, move
the saddle to a position comfortable
for doing exercise and then tighten the
knob (20) securely by turning it
clockwise.
4.- FITTING THE HANDLEBAR.-
Insert the handlebar stem (6) into the
hole on the main body, Fig.4. Position
it correctly and then tighten knob (109)
by turning it clockwise.
ADJUSTING THE HANDLEBAR
HORIZONTALLY.-
Position the handlebar (6) at a
comfortable
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (109) securely, Fig.5.
ADJUSTING THE HANDLEBAR
VERTICALLY.-
Position the handlebar (6) at a
comfortable
exercise but without going beyond the
"MIN INSERT" marks, now tighten
knob (20) securely, Fig.4.
5.- FITTING THE MONITOR.-
Position the handlebar (117) on the
handlebar stem (6), Fig.6, tighten the
knob (109). Take the monitor (116) and
remove the four screws (118) from the
base of the monitor, Fig.6. Place the
monitor (116) in the direction of the
arrow sliding the monitor on the
it
holding plate.
11
and
then
tighten
distance
for
distance
for
the
doing
doing
Publicité
