Publicité
Les langues disponibles
Les langues disponibles
Installation:
•
Remove the washer and wing nut from the packaged logo plate.
•
Insert the logo plate into the mounting hole on the front of the
cabinet door, place the washer on the thread pole on the inside of the
door, and hand-tighten by hand to secure.
NOTE: The logo plate is supplied with one washer and one wing nut.
13. MOUNTING THE CABINET DOOR HANDLE, DOOR LATCH
Parts Required:
Cabinet Door Handle (#6)
1
x
1
x
Cabinet Door Latch (#7)
4
x
#10–24x½" Screw (#C)
Installation:
•
First, re-mount the cabinet door to the main cabinet by aligning and
securing both hinges. Ensure the door is mounted correctly by testing
it opens freely. Note 13A.
•
Mount the cabinet door handle onto the front side of the cabinet door
using two screws. Note correct direction in 13B.
•
Mount the cabinet door latch onto the exterior side of the main
cabinet using two screws. Note 13C.
14. ASSEMBLING & INSTALLING THE WOOD CHIP TRAY
Parts Required:
1
x
Wood Chip Tray Lid (#10)
1
x
Wood Chip Tray Assembly (#11)
Installation:
•
First, assemble the wood chip tray assembly by securing the faceplate
and handle using two screws. Next, insert the wood chip tray lid into
the lid slots on the wood chip tray assembly and flip the lid down so it
closes. Note illustrations in 14A.
•
Slide the assembled wood chip tray into the opening above the control
board on the front panel of the unit. Note 14B.
15. INSTALLING THE GREASE TRAY
Parts Required:
Grease Tray (#24)
1
x
Installation:
•
Slide the grease tray into the opening below the control board on the
front panel of the unit. Ensure the grease tray sits properly on the rails.
•
The unit is now completely assembled.
12
5
13
13A
6
13B
14A
10
11
14B
15
24
8
7
13C
11
Publicité
