Bostitch DSA-3519-U Instructions D'utilisation page 13

A. Remove the magazine from the tool
B. Using a pair of pliers, remove the jammed staple
C. Refit the magazine
SERVICE PARTS LIST
m CAUTION: Repair, modification and inspection
of BOSTITCH Power Tools must be carried out by a
BOSTITCH Authorised Service Center.
The Parts List supplied with this tool will be helpful if
presented with the tool to the BOSTITCH Authorised
Service Center when requesting repair or other
maintenance.
TROUBLE SHOOTING
PROBLEM CAUSE
Loose magazine
Fasteners out of spec.
Skipping fasteners/
intermittent feed
Dirt/debris in the magazine
Dirt/debris in the drive channel
Wrong size fasteners
Bent fasteners
Broken/chipped driver
Worn pusher
Fasteners jam in the tool Loose magazine
Fasteners out of spec.
Dirt/debris in the magazine
Dirt /debris in the drive channel
Worn/damaged pusher spring
Discharged Battery
Slow drive speed or
Depleted Battery
stalling
Cardboard too thick
Wrong leg length setting
Poor clinch Worn driver guide
Broken/bent clinchers
Multiple fasteners driven
Loose magazine
at once
Depth setting too shallow
Staple is only clinching
Fasteners are too short
the top layer of corrugate
Cardboard too thick
Clinch setting too loose
Loose clinch
Fasteners are too long
All manuals and user guides at all-guides.com
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS
BOSTITCH tools are constantly being improved and
modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
CORRECTION
Re-engage the magazine release lever
Replace with recommended fasteners
Clean and dry the magazine
Clean the drive channel
Replace with recommended fasteners
Discontinue using these fasteners
Replace driver
Replace pusher
Re-engage the magazine release lever
Replace with recommended fasteners
Clean and dry the magazine
Clean the drive channel
Replace pusher spring
Recharge battery
Replace battery
Reduce cardboard thickness
Set leg length according to clinchers and fasteners
Replace the driver guide
Replace clinchers
Re-engage the magazine release lever
Set the tool to a deeper drive setting
Replace with longer fasteners
Reduce cardboard thickness
Adjust the clinch setting tighter
Replace with shorter fasteners
GB