Bostitch DSA-3519-U Instructions D'utilisation page 11

3. Do not pull the trigger or depress the safety trip as
accidental actuation may occur, possibly causing
injury.
m Note: See the technical specifications in the front
of this manual for specific loading instructions and
dimensions of recommended fasteners.
SAFETY INSTRUCTIONS FOR OPERATION
Always handle the tool with care:
• Never engage in horseplay;
• Never pull the trigger unless the nose is directed
towards the work.
• Keep others at a safe distance from the tool while
the tool is in operation, as accidental actuation may
occur, possibly causing injury.
• The operator must not hold the trigger pulled on
safety trip tools except during fastening operation,
as serious injury could result if the trip accidentally
contacts someone or something, causing the tool to
cycle.
• Keep hands and body away from the discharge area
of the tool.
• Check operation of the safety trip mechanism
frequently. Do not use the tool if the contact arm is not
working correctly, as accidental driving of a fastener
may result. Do not interfere with the proper operation
of the safety trip mechanism.
• Do not drive fasteners on top of other fasteners as
this may cause deflection of the fastener, which could
cause injury.
• Do not drive fasteners close to the edge of the work
piece as the wood may split allowing the fastener to
be deflected, possibly causing injury.
• Do not use this stapler for fastening electrical cables.
It is not designed for electric cable installation and
may cause damage to the insulation of electric cables
thereby causing electrical shock or fire hazard
SAFETY INSTRUCTIONS
FOR MAINTENANCE
To prevent accidental actuation and possible injury,
always disconnect the battery:
1. Before making adjustments.
2. When servicing the tool.
3. When clearing a jam.
4. When tool is not in use.
All manuals and user guides at all-guides.com
5. When moving to a different work area, as accidental
actuation may occur, possibly causing injury.
Check that the tool is functioning correctly by applying
the nose to a piece of scrap cardboard and pulling the
trigger once or twice.
3. USING THE TOOL
• Unauthorised persons (including children) must be
kept away from the equipment.
• Wear eye protection.
• Check the retaining screws which fix the top cover,
etc. for tightness. Check the tool for defective or rusty
parts.
• Check whether or not the contact arm works correctly
without staples and battery fitted in the tool.
• Ensure you have read and understood all the relevant
safety instructions in this manual before proceeding.
A. You must charge the battery before use- see previous
B. Insert battery into the handle of the tool (Fig. 2)
TOOL OPERATION CHECK:
THESE TOOL WILL CYCLE EACH TIME THE TRIGGER
IS PULLED AND THE SAFETY LEVER IS DEPRESSED!
THIS IS A FULL CYCLE TOOL. PULL THE TRIGGER, AND
CLINCHERS WILL DISCHARGE AND RETRACT
m CAUTION: REMOVE ALL FASTENERS FROM TOOL
BEFORE PERFORMING TOOL OPERATION CHECK.
A. With finger off the trigger, hold the tool with a firm
B. Place the nose of the tool against the work surface.
C. Ensure the additional safety lever on the tool handle
D. Pull the trigger or handle to drive.
LOADING THE TOOL
m CAUTION: Remove all fasteners from tool before
loading or unloading the staples.
A. Pull the pusher to the back of the magazine (Fig 4)
B. Check staple leg length: adjustment is provided for
C. Insert 2 sticks of staples into the channel and gently
section '1. CHARGING THE BATTERY'.
grip on the handle.
is depressed (Fig 3)
and secure it by rotating it round to the bottom of
the tool (Fig 5)
different staple leg lengths (see below).
release the pusher against the staples.
GB