Publicité
Les langues disponibles
Les langues disponibles
EN
•
Make sure the motor is not hot when you put the machine
into storage.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person of an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
You may lower the handle(s) before you put the machine into
the storage.
1. Fully loosen the handle fasteners on the sides of the
handle(s).
2. Fold away the handle(s).
3. Do not pinch or trap the cables.
10
TROUBLESHOOTING
Problem
The handle is not
in position.
The machine does
not start.
The machine cuts
grass unevenly.
The machine does
not mulch correct-
ly.
The machine is
hard to push.
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
The battery ca-
Charge the battery
pacity is low.
pack.
The bail switch is
Replace the bail
defective.
switch.
The battery key is
Put in the battery
not put in.
key.
The lawn is rough. Examine the mow-
ing area.
The blade height is
Move the wheels
not set correctly.
to a higher posi-
tion.
Wet grass clip-
Wait until the
pings attach to the
grass dries before
deck.
mowing.
The mulch plug is
Install the mulch
missing.
plug.
The grass is too
Increase the blade
tall, or the blade
height.
height is too low.
The grass catcher
Empty the grass
and the blade
clippings from the
drags in thick
grass catcher.
grass.
English
Problem
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
* If you cannot find the solution to these problems, go to the
service center.
11
TECHNICAL DATA
Voltage
24 V
No load speed
3550 RPM
Deck size
13"
Height adjust-
1" - 2 3/4" (2.5-7.0 cm)
ments
Functions
2-in-1 Mulch & Rear Bag
Weight (with-
21.2 lbs (9.6 kg)
out battery
pack)
Battery model
BAG709 and other BAG series
Charger model
CAG801 and other CAG series
12
Possible cause
Solution
The blade is un-
Replace the blade.
balanced and
worn.
The motor shaft is
1. Stop the mo-
bent.
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
The blade height is
Increase the blade
too low.
height.
The battery pack is
Charge the battery
out of power.
pack.
The grass clip-
Remove the bat-
pings attach to the
tery pack and
deck or the blade.
check the deck.
Operation temper-
Cool the machine.
ature of the ma-
chine is too high.
Publicité
