Publicité
Les langues disponibles
Les langues disponibles
4. Once the machine has started you can release the start
button(13).
8.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you
complete the work.
8.3
EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it from
the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
8.4
OPERATION TIPS
•
Do not try to override the operation of the start button or
bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9
MAINTENANCE
WARNING
Remove the safety key and battery pack from the machine
before maintenance.
WARNING
Keep the motor and battery pack free from grass, leaves or
too much grease.
CAUTION
Use only approved replacement parts.
English
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
9.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
9.2
REPLACE THE BLADE
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blades(20) fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw(18) and spacers(19) with a
wrench or socket.
7. Remove the blade(20).
8. Install the new blade. Make sure that the raised points
engage the holes in the blade.
9. Put in the mounting screw and spacers and tighten them.
9.3
STORE THE MACHINE
•
Clean the machine before storage.
11
CAUTION
CAUTION
WARNING
WARNING
EN
Publicité
