Craftmade MES60 Instructions D'installation page 10

10. LED Light Kit Assembly (Optional).
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come
through holes in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with
a Phillips screwdriver. [Refer to diagram 1.]
If you wish to use the LED light kit, remove 1
screw from underside of fitter plate and
partially loosen the other 2 screws.
Connect WHITE wire from LED light kit to
WHITE wire from motor housing. Connect
BLACK wire from LED light kit to BLACK (or
BLUE) wire from motor housing. Be sure that
molex connections snap together completely.
WARNING: Do NOT connect molex connections
for the LED light kit if you do NOT wish to use
the light kit.
Carefully arrange wiring within LED light kit.
Align slotted holes in LED light kit with
loosened screws in fitter plate. Twist LED light
kit to lock. Re-insert screw that was previously
removed and tighten all 3 screws securely.
[Refer to diagram 2.]
Align grooves on shade with nodules on inside
of LED light kit and push up gently on shade.
Twist shade to the RIGHT (clockwise) until
shade locks into place. Pull down VERY GENTLY
on shade to make sure that shade is secure.
[Refer to diagram 2.]
If you do NOT wish to use the light kit,
grooves on metal cover and align with nodules
inside LED light kit. Gently push up on shade
and turn to the RIGHT (clockwise)
longer turns. [Refer to diagram 3.]
WARNING: Metal cover will be HOT if light is
left on.
motor plate
molex connections
diagram 1
diagram 2
locate
nodules
until it no
diagram 3
page 10
LED light kit
slots
motor
housing
fitter plate
screw
motor
housing
fitter plate
molex connections
shade
motor
housing
metal cover