Publicité
Les langues disponibles
Les langues disponibles
IV. GETTING STARTED
Before any intervention on product, ensure that switch is off and battery
charger is disconnected form its power source.
4.1- Unpacking
Remove product from its packaging.
Check that tool and accessories are not damage.
4.2- Inserting and removing a socket
- To install a socket on the anvil: Align the hole of the socket with the anvil and push down firmly.
Ensure it is centered and properly fixed.
- To remove a socket from the anvil: Pull socket out firmly
4.3- Inserting and removing the battery (fig. 2)
(a) to insert the battery: slide the battery into the handle's base.
Make sure that the battery is securely locked.
(b) to remove the battery: press the release tabs (7) and slide the battery out of
the handle's base.
4.4- Charging the battery (Fig. 3)
1- Place battery charger on a flat and dry surface within 1m of a wall socket.
2- Insert battery into charger
3- Plug in battery charger to wall socket (power source)
(Only use with provided charger PRI 100-240V~50Hz 75W, SEC 18V
2500mA)
4- Charge during 1 hour.
5- After charging, disconnect battery charger from mains.
Note: Maintain the charger and the battery at a temperature between +10°C et
+40`°C
4.5- Battery charger LED indicator (Fig.4)
The battery charger LED indicator (9) allows you to know the charging status
of your battery
Green LED illuminated means the charger is plugged and powered ON.
When red LED is on:
Slow blinking: battery pack is charging.
Fast blinking: battery pack may be defective (*)
LED steady on : battery pack is fully charged
(*) Stop using the battery pack and acquire a new one at your local dealer.
4.6- Switch On/Off (Fig. 5)
To operate product, press on switch (3).
To stop product, release the switch.
4.7- Changing to Forward or Reverse mode (Fig. 5)
To change the rotation, press on the Forward/Reverse selector (2).
Note: do not abruptly change rotating direction when machine is operating.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Page 18 / 29
Publicité
