Publicité
Les langues disponibles
Les langues disponibles
unless they have been given supervision or instruction concerning use of the product by a person
responsible for their safety.
5. Do not use the tool in wet or damp conditions, areas. Keep work area free from tipping hazards.
6. Never change the rotation direction of the chuck while the tool is still running. Ensure that the
chuck has come to a complete stop before changing rotation direction.
7. Never put down the tool unless the tool is switched off and the chuck has come to a complete
stop. (Note: ensure that chuck is no longer rotating when you put down the tool.)
8. Keep hands and other body parts well away from the workpiece while tool is in use.
9. When using tool for screwing/unscrewing, place the socket on the chuck head only when power
tool is switched off.
10. Residual risks
Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The
following hazards may arise in connection with the tool's construction and design:
a. Damage to lungs if an effective dust mask is not worn.
b. Damage to hearing if effective hearing protection is not worn.
c. Health defects resulting from vibration emission if the power tool is being used over longer period of
time or not adequately managed and properly maintained.
d. Health hazard resulting from dusts from materials containing harmful substances.
Wear hearing protection while operating the power tool.
10.1. Noise level
Wear ear protection
The measured values have been measured in accordance with a standard test method.
The measured values are mentioned in the characteristics table.
10.2. Vibrations level
The declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
Warning! The vibration emission during actual use of the power tool can differ from the declared total
value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
11. Electrical Safety
Always check that the voltage of the power supply matches the voltage indicated on the tool's rating
plate.
12. If the power cable is damaged, it must be replaced by the manufacturer, its after sales service or a
person with similar qualification in order to avoid any danger.
If the power cable or extension cord is damaged or cut during operation, immediately disconnect plug
from its main power source. Do not touch the cable or extension cord before unplugging from main
power.
13. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
Page 17 / 29
Publicité
