Features; Door Reversal Instructions - Danby Designer DUFM082A1WDD Guide D'utilisation Et Soins De Propriètaire

1) THERMOSTAT DIAL: For controlling the temperature
inside the freezer. Turns the motor on as soon as the
temperature rises above the desired level.
2) REFRIGERATED SHELVES: 3 full width refrigerated
shelves.
3) MAGNETIC GASKET: Tight fi tting door seal keeps all
the cooling power locked inside. No hooks or latches.
4) DOOR BINS (4)
5) DRIP TRAY

DOOR REVERSAL INSTRUCTIONS

CAUTION
To avoid personal injury to yourself and/or property, we recommend someone assist you during the door rever-
sal process.
1) To access the lower hinge assembly, tilt back the freezer cabinet
or lay the freezer on its back. (Fig. B)
2) Remove both leveling legs located at the front of the cabinet.
3) Remove the screws holding the lower hinge assembly to the cabi-
net. (Fig. B)
4) Remove the main door assembly from the freezer cabinet (lift door
slightly and pull downward).
5) Using a regular fl at head screwdriver, remove the main door top
hinge pin.(Fig. C)
6) Re-install the main door top hinge pin on the opposite side of the
cabinet. (Fig. C)
7a) Remove the door plug and door bushing located on the top of the
main door.
7b) Interchange their positions (e.g.door plug right side, door bushing
left side).
8) Re-install main door assembly on cabinet.
9) Remove door bushing (bottom door) and install on opposite side.
Bushings must be inserted in the bottom of the door on both sides.
See Fig. A.
10) Re-install the lower hinge assembly on the opposite side.
11) Make sure the door assembly is properly aligned on the cabinet
before tightening lower hinge screws. (Fig. B)
12) Re-install both leveling legs. The process is now complete.

FEATURES

1
2
5
3
Insert bushings to the bottom
of the door on both sides.
Insert the washer (4.5mm thick) onto the
hinge followed by the bushing.
Fig. B
Use a 10mm socket with ratchet
to remove / install the hinge.
3
4
Fig. A
Fig. C