Publicité
Les langues disponibles
Les langues disponibles
14
Problem
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the appli-
ance is too low/too high.
All manuals and user guides at all-guides.com
Possible cause
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
The FastFreeze or Intensi-
veCooling function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
The FastFreeze function is
switched on.
The IntensiveCooling func-
tion is switched on.
There is no cold air circula-
tion in the appliance.
Solution
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or Inten-
siveCooling manually, or wait
until the function resets auto-
matically to set the tempera-
ture. Refer to "FastFreeze or In-
tensiveCooling function".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room temper-
ature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "FastFreeze function".
Refer to "IntensiveCooling func-
tion".
Make sure that there is cold air
circulation in the appliance.
Publicité
