Publicité
ATTENTION: PLEASE DO NOT!
(Follow these instruction closely for the best espresso making experience)
1. DO NOT attempt to unscrew Water Reservoir Cap OR remove Filter Holder
without releasing pressure first. To release the pressure, immerse the tip
of the Frothing Aid into a Frothing Pitcher with a small amount of water
in it. SLOWLY TURN THE CONTROL KNOB TO THE
RELEASE THE STEAM. When the Frothing Aid stops releasing steam,
turn the Control Knob to the"OFF" position and slowly remove the Water
Reservoir Cap. This will both release the pressure in your unit and clean
the Frothing Aid.
2. DO NOT apply pressure to the Filter Retainer Clip when turning Filter into
the Lock position. This may cause the Filter Retainer Clip to break.
3. DO NOT attempt to push the Filter Holder past the Lock position.
4. DO NOT remove the Filter Holder at any
time during the brewing process or until
pressure is relieved.
5. DO NOT overfill the Filter with ground coffee,
as this will cause an improper lock of the
Filter Holder, which could result in leaking and
damage the seal.
6. DO NOT leave excess coffee grounds on the edge of the Filter Holder.
Excess grounds on the edge will cause improper lock which could result
in leaking and damage to the seal.
7. DO NOT
or
8. DO NOT immerse appliance in water.
9. DO NOT touch metal parts of Filter Holder until unit has cooled.
Metal parts may still be hot immediately after brewing.
10. DO NOT leave water in the Water Reservoir between uses.
11. DO NOT store the Filter Holder in the brew head. This can cause
improper lock which could result in leaking and damage to the seal.
12. DO NOT fill water to the top of the Water Reservoir.
the appliance without water in the Water Reservoir.
13 5
POSITION AND
Removing excess grounds
Publicité
