Publicité
Les langues disponibles
Les langues disponibles
6. Final Installation.
Remove canopy assembly from j-hook on
mounting plate and carefully push wiring
and wire connectors into outlet box. Align
slotted holes on top rim of canopy assembly
with loosened screws in mounting plate.
Twist canopy assembly to lock. Re-insert
the 2 screws that were previously removed
(Section 3, page 4) and then tighten all
4 screws to secure canopy assembly.
Using the Allen wrench, tighten the 2 Allen
screws located in the outer circle on the
underside of the canopy assembly. These
2 Allen screws must be tightened securely
to hold the fan at the desired angle.
WARNING: Failure to securely tighten the
2 Allen screws in the outer circle of the
canopy assembly may result in the fan
wobbling or possibly falling.
Align tabs on canopy ring with 4 grooves at
top of canopy assembly. Then, raise canopy
ring to grooves. [NOTE: The tabs must fit into
the grooves to ensure a secure fit.]
To complete installation of your fan, refer
once again to the instructions in the
installation manual for your fan. Should there
be an issue with the slope mount adapter,
please refer to the "Troubleshooting" section
to the right.
PLEASE NOTE: If there are issues with the
fan, you must consult with the Customer
Service number provided in the installation
manual for the fan or with the manufacturer
of the fan.
Parts Replacement.
For parts and information, please refer to
"Parts Inventory" on page 3.
Craftmade Customer Support:
1-800-486-4892
www.craftmade.com
KHLI2203
slotted
hole
groove
Allen wrench
tab
Troubleshooting.
WARNING: Failure to disconnect power supply
prior to troubleshooting any wiring issues may
result in serious injury.
Problem: Fan fails to operate.
Solutions:
1. Check wall switch to fan.
2. Check to be sure fan is wired properly.
Problem: Fan wobbles.
Solutions:
1. Lower canopy ring and carefully loosen
canopy assembly in order to verify that
mounting plate is secure.
2. Check to be sure pin in canopy assembly
yoke is tightened securely.
3. Check to be sure Allen screws on canopy
assembly yoke are tightened securely.
4. Check to be sure Allen screws in outer circle
of canopy assembly are tightened securely.
Problem: Fan uneven when hanging.
Solution:
1. Check to be sure both Allen screws in outer
circle of canopy assembly were tightened
securely after canopy assembly was attached
to mounting plate.
page 6
mounting
plate
canopy
assembly
canopy ring
Publicité
