Publicité
Les langues disponibles
Les langues disponibles
1. Parts Inventory.
Check against parts inventory that all parts
have been included.
a. mounting plate. 1 piece
b. canopy assembly. 1 piece
PLEASE NOTE: All drawings appearing in this
manual for fan parts not provided with this accessory
are representative only.
2. Installation Preparation.
To prevent personal injury and damage, ensure
that you have allowed the blades a clearance of
7 feet (213 cm) from the floor and 30in. (76 cm)
from any wall or obstruction.
This slope mount adapter is made to be used
with a ceiling fan that is installed with a
downrod on an angled (or vaulted) ceiling. The
slope mount adapter CANNOT be used with
flushmount installation.
Installation requires these tools:
Phillips screwdriver, flathead screwdriver and
stepladder
3. Mounting Plate Installation.
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light
switch is turned to the OFF position.
WARNING: Failure to disconnect power supply
prior to installation may result in serious injury.
["Mounting Plate Installation" continued on
next page.]
c. canopy ring. 1 piece
d. Allen wrench. 1 piece
a
c
d
blade edge
downrod
installation
page 3
b
30
inches
(76cm)
7 feet
(2.13m)
flushmount
installation
Vaulted ceiling
angle is not to
exceed 60 degrees.
Publicité
