Torin BIG RED T815016L Manuel Du Propriétaire page 6

ASSEMBLY
1. Familiarize yourself with the jack.
Lifting Arm
Rear Swivel Casters
2. Prior to assembly, carefully remove the retaining
stopper attached to the handle socket. CAUTION:
The socket will tend to spring upward when the
stopper is removed. To prevent possible injury,
place one hand on the top of handle socket to
control the upward motion of the handle socket
retaining stopper, and then carefully remove the
retaining stopper. After removed slowly allow
handle socket to rise back into resting position.
WARNING!
Once retaining stopper is removed,
SLOWLY allow handle socket to rise
back into resting position. Use
CAUTION when removing retaining
stopper, handle socket will spring forward
rapidly.
Saddle
Front Wheel
Pump Plunger
Stopper
3. Refer to picture below when performing
assembling handle sections. Press Quick
Disconnect on handle piece 2, this will allow
slide handle pieces 1 and 2 to connect, align the
holes on both sections to allow quick disconnect
to trigger. Quick disconnect pin on handle piece
2 will automatically pop out of handle piece 1
coupling position when aligned properly.
Handle
Pc. 1
4. Unfasten the screw located in the Handle Socket
to insert the assembled handle.
Handle Socket
Screw
5. Line up the square hole located at the bottom of
the handle over the square bolt inside the Handle
Socket.
6. Secure the handle in place by tightening the screw
in the handle socket without any vehicle on the
jack. Cycle the lift up and down several times to
insure the hydraulic system is operating properly.
(Perform the System Air Purge Procedure before
first use.)
WARNING: Do not lift or carry jack by handle.
Handle could dislodge and jack may fall,
resulting in possible injury or property damage.
6
Handle
Pc. 2
Quick
Disconnect