Glacier bay HD873X-0801 Guide D'installation Et D'entretien page 10

Installation (continued)
7
Installing the shower arm
□
Insert the long end of the shower arm (B) through
the shower ange (A), and wrap thread sealant
tape (not included) around the long end of the
shower arm (B) in a clockwise direction, as
shown.
□
Install the long end of the shower arm (B)
into the pipe elbow inside the wall. Carefully
tighten the shower arm (B) with a clean strap
wrench. Do not over tighten.
□
Wrap thread sealant tape around the pipe
threads of the tub spout outlet (1, not included)
in a clockwise direction, as shown.
□
Connect the tub spout outlet pipe (the tub
spout outlet pipe should project 1 in. to
2-15/16 in. from the nished wall) to the lower
pipe elbow (2, not included). Tighten the elbow
and tub spout outlet pipe connections with a
strap wrench.
A
B
2
1
1 in. to 2-15/16 in.
1
Wall
8
Installing the tub spout
□
Place the spout (J) onto quick connection until
the spout (J) becomes ush with the nished
wall and tighten the screw (1) with with the
Hex wrench (Hex: 3.97mm, O) provided.
J
1
O
10