TREND KWJ700 Traduction Des Instructions Originales page 11

Setting up for the Right Hand 45
7a)
Routing the Right Hand 45
7b)
Routing the Right Hand 45
7c)
Cutting bolt recess slots for Male 45
7d)
bolt.
Setting up for the Left Hand 45
8a)
Routing the Left Hand 45
8b)
cuts x 6.
Routing the Left and 45
8c)
Cutting bolt recess slots Female 45
8d)
Setting up for the Left Hand 45
9a)
Routing the Left Hand 45
9b)
x 6.
Routing the Left Hand 45
9c)
Cutting bolt recess slots for Male 45
9d)
bolt.
Square End Routing of Worktops
CL
Start Here
PF
The jig can be used to square cut the worktop using the
central slot. Engraved lines on the jig correspond to the
edge of the worktop. Up to 650mm wide worktops can
be square cut using the central slot with the KWJ700 as
a router guide and up to 850mm wide with the KWJ900.
Follow the cutting instructions on previous pages to cut
the worktop.
Peninsular Joint
5 2 4 1
Female Female
Male Male
Cut with
laminate up
Male Joint.
O
Male roughing cuts x 5.
O
Male Joint finishing cut.
O
connecting
O
Female Joint.
O
Female Joint roughing
O
Female Joint finishing cut.
O
connecting bolt.
O
Male Joint.
O
Male Joint roughing cuts
O
Male Joint finishing cut.
O
connecting
O
CL
Engraved lines
3 2 4 3
Male Male
Cut with
laminate down
EN - KWJ700/900
Rout cuts
the curved peninsula
Routing the Curved Peninsular
PF
CL
Start Here
8.5mm
Routing 3/4" BSP Hole
Please check hole size is suitable for
mixer tap.
• Mark position of hole for tap in worktop.
• Place jig in position so that hole in jig is over
hole position.
• Secure the jig with clamps.
• Set the depth of cut for 8-10mm and plunge cut.
• Repeat at different depths until hole is routed.
Routing 35mm Circular Hinge Recess
• Mark the position of the hinge on the door. The centre
of the holes should be roughly 100mm from the top
of the door to give the required support, ensure this
measurement is as accurate as possible.
• Position the jig on the door.
• Set the depth for 10mm.
• Repeat operation increasing the cut by 1mm, therefore
setting the total depth for 11mm. (This should be
enough clearance for most hinges. Adjust this
measurement if you require holes for thicker hinge
heads).
-11-
and before routing
CL
8.5mm
100mm
5.5mm