Publicité
Les langues disponibles
Les langues disponibles
Installation
Safety
If the safety instructions and warnings are not followed, the
manufacturer cannot be held responsible for any resulting damage.
This appliance should only be connected by a registered installer.
Prior to installation, ensure that the local distribution conditions
(voltage, frequency, nature of the gas and gas pressure) and the
adjustment of the appliance are compatible.
The voltage, frequency, power, type of gas and the country for
which the appliance has been designed are shown on the
appliance rating plate.
Check the appliance for transport damage. Do not connect a
damaged appliance.
The walls and the worktop surrounding the appliance must be
heat resistant up to at least 105 °C.
The worktop into which the hob is fitted should be flat.
Electrical connection
This appliance must be earthed.
The electrical connection must comply with national and local
regulations.
For class I appliances, check that your home's electrical system
provides proper earthing.
The wall plug socket and plug should always be accessible.
If a stationary appliance is not fitted with a supply cord and a
plug, or with other means for disconnection from the supply mains
having a contact separation in all poles that provide full
disconnection under overvoltage category III conditions, the
means for disconnection must be incorporated in the fixed wiring
in accordance with the wiring rules. Using an omnipolar switch
with a contact separation of at least 3 mm fitted in the supply
cable will fulfil this requirement.
The connection cable must hang freely and should not be fed
through a drawer.
34
Publicité
