Installation Requirements; Tools And Parts; Location Requirements - KitchenAid 740-0780 Instructions D'installation Et Guide D'utilisation Et D'entretien

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
■
Tape measure
■
Small, flat -blade screw driver
■ #2 and #3 Phillips screw driver
■ Level
■
Wrench or pliers
Parts Supplied
■
Gas pressure regula tor/hose assembly set for 11" WCP LP
gas.
■
1 - "AA" size alkaline battery
■
20 lb LP gas fuel tank tray
■ 12 screws (for inst alling 20 lb LP gas fuel tank tray, 90° clamp/
Natural gas regulator clamp)
■ Hardware packe t
■
2 piece 90° clamp (for mounting 90° connector)
■
Hex wrench (for loosening control knobs)
■ Warming rack
Parts Needed
■
20 lb LP gas fuel tank
Parts Supplied for Conversion to Natural Gas
■
Natural gas conversion kit (which includes):
■
Natural gas regulato r (marked "Natural Gas Regulator")
■
10 ft (3.0 m) PVC flexible gas supply hose with quick
connector
■
6 mm nut drive r
Natural gas regulator clamp
■
■
2.05 mm Natural gas orifice for rotisserie/infrared burner
Parts Needed for Conversion to Natural Gas
■ Gas line shut off valve
■ ½" male pipe thread nipple for connection to pressure
regulator.
■
LP gas-resistant pipe-joint compound
■ CSA d esign -certified outdoor flexible stainless steel appliance
connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as
needed.

INSTALLATION REQUIREMENTS

■
Pipe wrench
■
Scissors or cutting pliers
(to remove tiedowns)
■ Noncorrosive leak-
detection solution

Location Requirements

WARNING
Explosion Hazard
Do not store fuel tank in a garage or indoors.
Do not store grill with fuel tank in a garage or indoors.
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
Do not use grill near combustible materials.
Do not store combustible materials near grill.
Doing so can result in death or fire.
Select a location that provides minimum exposure to wind and
traffic paths. The location should be away from strong draft areas.
Do not obstruct flow of combustion and ventilation air.
Clearance to combustible construction for outdoor grills:
A minimum of 24" (58.0 cm) must be maintained between the
front of the grill hood, sides and back of the grill and any
combustible construction.
A 24" (58.0 cm) minimum clearance must also be maintained
below the cooking surface and any combustible construction.
Rotisserie (accessory)*
If you equip your grill with a rotisserie, a 6" (15.2 cm) minimum
clearance is needed for the rotisserie motor.
A grounded, 3-prong outlet located to the left of the grill is
required.
*See "Assistance or Service" section to order.
5