ION Pro Glo Duo iPA96D Guide D'utilisation Rapide page 4

Quick Setup
Connection Diagram
Items not listed under
Introduction > Box Contents
are sold separately.
Speaker Stand Installation
1. Fully extend the speaker stand tripod legs on a flat, stable
surface. Look in the box contents under the foam sheet for the
rubber feet and speaker stand mounting knob.
2. Raise the mounting pole up to the appropriate height needed
and tighten the side adjustment knob.
3. Insert the pin into the bottom pin-hole so the mounting pole
stays at your set height.
4. On PA Glow 10, adjust the bottom knob counter-clockwise so
the screw is not blocking the opening.
5. Line up the PA Glow 10 mounting hole with the speaker stand
pole and place on the pole.
6. Tighten the mounting knob clockwise on PA Glow 10.
3
4
SD Card
Microphones
Tablet
4
USB drive
Smartphone
Power
1
2
5/6
5/6