Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE.-
Use the bottle of lubricant (97) to
lubricate the inside of the belt Fig.6 in
order to keep your unit in top condition
and to ensure that friction between the
belt and the board is kept to a
minimum (due to different running
styles, always apply more lubrication
to the area where you place your feet
during the exercise).
It is advisable to lubricate the base of
the belt between the board and the
band depending on how often it is
used.
<6
>6
Note:
This
preventive
schedule is only meant for home use.
In aggressive environments, with high
dispersion of particles or with heavy
weight
people,
should be increased accordingly.
If the belt starts to slip after lubrication,
then check the tension of the belt. To
tension the belt, take the 6 mm Allen
key (110) and with the machine set to
4 km/h turn screws (R & L) one turn in
a clockwise direction.
ADJUSTING THE BELT.-
If your unit is not seated evenly on the
four contact points, this may cause the
belt (X) to shift sideways. Rigorous
quality control adjusts and checks the
running belt. However, due to weight
differences and individual styles of
running, the belt may be prone to shift
sideways.
Hours per week
<=7
>7
1
1 month
month
2
1 month
months
maintenance
lubrication
frequency
If the belt does shift to the left or right,
stop the machine.
BELT OFFSET TO THE RIGHT.-
This procedure is very important.
Follow these steps. In order to adjust
the belt, set the unit in motion at a
speed of 4km/h. If the belt has moved
to the right, turn screw (R) on the
right-hand side of the machine a 1⁄4
turn clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the left then turn
the right screw back slightly in an
anticlockwise direction Fig.7.
As soon as you have adjusted the belt
you can begin exercising again.
BELT OFFSET TO THE LEFT.-
In the event that the belt has moved to
the left, turn screw (L) on the left-hand
side of the machine a 1⁄4 turn
clockwise. Note the position of the
belt, if after one minute the belt is not
completely centred then repeat the
operation. If you see that the belt has
moved too far over to the right then
turn the left screw back slightly in an
anticlockwise direction Fig.7.
Important: Overtightening of the belt
can lead to a loss of speed on the
machine and even stretch the belt
itself.
Bear in mind that one turn of the right
screw (R) in a clockwise direction has
the same effect on the position of the
belt as one turn of the left screw (L) in
an
anticlockwise
Consequently,
excessive belt movement you can use
either of the two screws in order to
avoid overtightening the belt.
16
direction.
in
the
event
of
Publicité
