ESAB Aristo Mig 5000i Manuel D'instructions page 19

US
6 INTRODUCTION
The Mig 5000i is a GMA welding power source, which can also be used for SMAW
(Shielded Metal Arc Welding ).
The power source is intended for use with the Feed 3004 or Feed 4804 wire feed
units.
All settings are made from the wire feed unit or control box U8.
ESAB's accessories for the product can be found on page 40.
6.1 Equipment
The power source is supplied complete with terminating resistor and instruction
manual.
7 TECHNICAL DATA
Mains voltage
Primary current
I GMAW
max
I SMAW
max
No-load power demand when in the energy-saving mode,
6.5 min. after welding
Voltage/current range
GMAW
GMAW, control panel M2
SMAW
Permissible load at GMAW
60 % duty cycle
100% duty cycle
Permissible load at SMAW
60 % duty cycle
100% duty cycle
Power factor at maximum current
Efficiency at maximum current
Open-circuit voltage U
GMAW without VRD function
SMAW without VRD function
GMAW, SMAW, VRD function deactivated
VRD function activated
Operating temperature
Transport temperature
Dimensions, lxwxh
Continual A-weighted sound pressure
Weight
Insulation class transformer
Enclosure class
Application class
ba38d1aa
Mig 5000i
max
0
1)
1)
2)
2)
460V, $10%, 3∼ 60 Hz
31 A
32 A
70 W
8-60 V / 16-500 A
8 - 42 V
4 - 500 A
500 A / 39 V
400 A / 34 V
500 A / 40 V
400 A / 36 V
0.90
87 %
72 - 88 V
68 - 80 V
59 V
< 35 V
-10 to +40° C
-20 to +55° C
24.6"x 15.5" x 19.5"
<70 db
150 Ibs
H
IP 23
- 19 -
© ESAB AB 2003