Publicité
Les langues disponibles
Les langues disponibles
6. Remove all burner caps and burner bases. Be sure to keep
the cap and base for each burner together. This will assure
that the cap and base are reinstalled on the proper burner.
F
E
A. Gas tube opening
B. Burner cap
C. Burner base
7. To convert burners:
Insert 7.0 mm nut driver down onto the gas orifice
■
spud (C) and remove by turning it counterclockwise
and lifting out.
Set gas orifice spud aside.
■
Replace with correct LP gas orifice spud. See the
■
LP Gas Orifice Spud Chart.
B
A
C
Standard and
simmer burners
A. Igniter electrode
B. Orifice holder
C. Orifice spud
IMPORTANT: Place Natural gas orifice spuds in plastic
parts bag for future use and keep with package containing
literature.
A
B
C
D
D. Orifice holder
E. Igniter electrode
F. Burner base notch or hole
C
B
A
Dual flame burner
A. Igniter electrode
B. Orifice holder
C. Orifice spud
D. Orifice simmer
8. Replace burner bases and burner caps.
IMPORTANT: Be sure that the electrode aligns with the
notch or hole in the burner base. The igniter electrode is
ceramic and could break during installation of the burner
base.
9. Open shut-off valve in the gas supply line. The valve is open
when the handle is parallel to the gas pipe.
10. Once you have completed converting all of the cooktop
burners, test the cooktop for leaks by brushing on an
approved noncorrosive leak-detection solution. If bubbles
appear, a leak is indicated. Correct any leaks found.
D
11. Plug in cooktop or reconnect power.
12. Adjust valve according to the "Low Flame Height
Adjustment" section.
A
C
B
A. Burner cap
B. Electrode
C. Burner base
5
Publicité
