Westfalia 84 38 60 Mode D'emploi page 21

Before first Use
Unpack the metal cutting saw and check all parts for any damage in transit.
Dispose of packaging materials or store it out of reach of children. Plastic bags
etc. may become a deadly toy for children.
The metal cutting saw is supplied only partly assembled.
Intended Operation
 The metal cutting saw is designed for cutting solid and hollow metal
workpieces only. The saw is ideal for dry-cutting tubes, section and solids
of steel (no high-grade steel), aluminium and copper. The high-power
machine is for dry cutting only. With the dry cutting method, not cooling
fluid is necessary. The vice can be adjusted up to 45°.
 When using a high-quality metal cut-off disc, fast and clean cuts can be
performed. The material will hardly get warmed, so the workpiece can be
processed immediately after cutting. Furthermore there will be less spark-
ing.
Unlocking the Metal Cutting Saw
1. The metal cutting saw will be delivered in the locked down position on the
base plate during transport.
2. To unlock the metal cutting saw slightly push the machine down – holding
it on the handle (1) – and lift up the locking bolt. The spring-loaded locking
mechanism will spring back, so the metal cutting saw can be lifted up-
wards.
3. For locking the metal cutting saw in place, first push the handle (1) up to
the end down on the base plate and push the locking bolt in direction to
the housing. Re-position the locking bolt into the provided notch.
Operation
Locking-
bolt
17