Publicité
Les langues disponibles
Les langues disponibles
7. Troubleshooting
PROBLEM
The electric plug is not inserted in the socket.
The appliance
The head is not lowered and/or not correctly
does not start
locked.
The S
The amperometric protection has been acti-
vated following overheating.
The protection fuse has blown.
The appliance is not located on a flat or suffi-
The appliance is
very noisy
ciently stable surface.
There is a vibration caused by loose screws or
bolts.
A quantity of product is being used which is
greater than that recommended or an at-
tempt is made to process a mixture which is
too hard or at a speed different from that rec-
ommended.
Bowl not correctly locked and/or rubber
spacer beneath bowl damaged/missing.
A quantity of product is being used which is
The appliance
slows down or
greater than that recommended or an at-
blocks during
tempt is made to process a mixture which is
processing
too hard or at a speed different from that rec-
ommended.
The cooling air vents fitted on the rear of the
appliance at the silver-plated strip are
blocked.
The above cases are presented merely by way of examples of possible problems. In the event of
any problem, switch Off the appliance immediately and contact the dealer.
The following characteristics are normal and do not represent malfunctions:
Slight oscillation during operation: a slight oscillation of the appliance during operation, espe-
cially at higher speeds, is absolutely normal. It is nonetheless necessary to check that the ap-
pliance has been positioned on a stable and correctly levelled surface.
Requesting spare parts:
To request spare parts, contact the dealer and refer to the part number, as indicated
in the spare parts drawings at the end of this handbook. At the same time, provide the
model and serial number of the appliance, as indicated on the technical specs. label
(ref. Pic.1 and Pic.2 - Section 8).
TRANSLATION OF THE ITALIAN ORIGINAL INSTRUCTIONS
POSSIBLE CAUSES
button has not been pressed.
TART
SOLUTIONS
Insert the plug in the electric socket.
Lower the head and check that it is correctly
locked (ref. paragraph 5.4).
Press the green S
TART
desired speed using the speed regulator
knob.
Wait 30 minutes for the appliance to cool
down before trying again to start it.
Contact the dealer to request technical sup-
port.
Position the appliance on a flat and stable
surface, which is suitable for supporting it
(ref. paragraph 5.2).
Check that the screws and bolts have not be-
come loose during operation or transport.
Consult Tab.2 - Section 10 to check the tool
and the correct speed as well as the right
type and quantity of product to be processed.
Correctly lock the bowl in its seat and/or re-
place the rubber spacer beneath bowl (ref.
Section 12).
Consult Tab.2 - Section 10 to check the tool
and the correct speed as well as the right
type and quantity of product to be processed.
Clean the air vents and remove any obstruc-
tions using a soft brush and a vacuum cleaner
(ref. paragraph 6.2).
button and adjust the
- 33 -
Publicité
