Nolan N21 VISOR Sécurité Et Instructions D'utilisation page 9

N21 VISOR
the inner polystyrene shell, the outer shell and the VPS side guides (Fig.14).
1.4 Unhook the left rear flap of the liner from the support fixed to the polystyrene
inner shell by slightly pulling the comfort padding towards the inside of the helmet
(Fig.15). Then repeat the same steps for the central and right flap.
1.5 Remove the chin straps from the elastic loops on the straps and the from the liner
side slots (Fig.16A).
1.6 Completely remove the liner from the helmet.
2 INNER COMFORT PADDING ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base
2.2 Pull the left rectangular textile extension of the liner (Fig.16B) and insert the chin
strap into the corresponding slot in the lateral side of the liner (Fig.16A) then fold
the rectangular textile extension of the liner inside the padding. Follow the same
steps on the right side of the helmet.
2.3 Insert the right and left sides of the liner in the cavity between the inner polystyrene
shell, the outer shell and the VPS side guides (Fig.14).
2.4 Insert the central rear flap of the liner into its seat on the support fixed to the poly-
styrene inner shell and push it downwards until it is completely locked. Follow the
same steps for the right and left rear flaps. (Fig.15).
2.5 Insert the left front flap of the liner into its seat on the support fixed to the poly-
styrene inner shell and push it downwards until it is completely locked. Follow the
same steps for the central and right flap (Fig.13).
check the correct assembly of the liner front area by lifting and lowering the
VPS. These movements should be smooth. If this is not the case, repeat the
steps 1.2. and 2.5.
2.6 Insert the chin straps in the elastic loops on the straps and pull it towards the
inside of the helmet.
WARNING
- Remove the inner comfort padding only when cleaning or washing is require.
- Never use the helmet if the all parts of inner comfort padding have not been cor-
rectly and completely reassembled
- Before washing the inner comfort padding, make sure to remove all the removable
sponge parts. Replace them correctly after washing.
- Delicately hand-wash in lukewarm water (max. 30° C) and neutral soap.
- Rinse with cold water and allow drying at room temperature, away from direct
sunlight.
- Never machine-wash the inner comfort padding.
- The inner polystyrene is an easily deformable material. It is apt to change or get
partially destroyed to help absorb shocks.
- Do not modify or alter the helmet's internal polystyrene components in any way.
- Clean the inner components with a damp cloth only and allow it to dry at room
temperature away from direct sunlight.
- Never use tools or equipment of any sort to carry out the steps described above.
16
INSTRUCTIONS FOR USE
HELMET LOCK RING
Some versions of this helmet feature a metallic ring called HELMET LOCK RING
(Fig.17), that can be used for hanging the helmet to the special hook placed on many
motorbikes.
WARNING
- Only use the HELMET LOCK RING to hang the helmet to the motorbike.
- Check that - when hung to the hook- the helmet is not directly exposed to heat
sources or other stresses that may modify its characteristics or damage it.
- the HELMET LOCK RING is not related to the helmet retention system (strap) and/
or its adjustment (see specific instructions).
- Never use the HELMET LOCK RING to fasten the helmet to the head and/or to
adjust the tension (see instructions above).
- Do not remove the HELMET LOCK RING form the retention system strap.
- In case of malfunctioning or damages, please contact an authorised Nolangroup
dealer.
N21 VISOR
17
INSTRUCTIONS FOR USE