Télécharger Imprimer la page

Bissell Little Green 1400 Serie Guide De L'utilisateur page 8

Masquer les pouces Voir aussi pour Little Green 1400 Serie:

Publicité

Les langues disponibles

Les langues disponibles

C
leaning with your Little Green
1.
Hold the tool approximately 1" (2.5 cm) above the
soiled surface. Press the Spray Trigger to apply
the cleaning solution to the soiled area.
2.
Using the brush on the tool, gently scrub the area
to be cleaned.
Note: If using the TurboBrush, the switch 
should be in the "BRUSH" position. This  
activates the brush only.
3.
For thorough cleaning, spray additional solution,
while the brush and suction are in contact with
the surface.
4.
Apply downward pressure on the tool and pull it
toward you. The suction will remove the dirt and
cleaning solution. Continue until no more dirt can
be removed.
Note: If using the TurboBrush, move the 
switch to the "SUCTION" position. This 
activates the suction to remove the dirt and 
cleaning solution. Move the switch back to 
the "BRUSH" position for additional brush-
ing action.
5.
As a final step, use "drying strokes" (by not press-
ing the Spray Trigger) to remove as much liquid/
moisture as possible. Repeat this step as often as
necessary.
Note: If using the TurboBrush, move the 
switch to the "SUCTION" position. This  
activates the suction to remove the dirt and 
cleaning solution.
A
fter Cleaning
1.
Turn Power Switch to OFF position.
Note: If your unit has a Built In Heater turn 
the Heater Switch off.
2.
Unplug Power Cord from outlet.
Note: If a significant amount of Little Green  
formula/water remains, it is all right to 
leave it in the Clean/Solution Tank for your 
next cleaning task.
3.
Empty and rinse the Dirty/Collection Tank after
each use, OR when dirty water reaches the
indicated maximum fill line. To remove the tank,
lift up the Dirty/Collection Tank retainer lever and
remove the tank from the unit.
8
w w w . b i s s e l l . c a
All manuals and user guides at all-guides.com
   
IMPORTANT:
Check the manufacturer's tag before 
cleaning upholstery. "W" or "WS" on the 
tag means you can use your Little Green. 
If tag is coded with an "S" (with diagonal 
strike-through), or says "Dry Clean Only," 
do not proceed. If manufacturer's tag is 
missing or not coded, check with your 
furniture dealer.
Tip:
Tip:
Deep clean-
Check uphol-
ing stairs and
stery stuffing
high-traffic
before cleaning.
areas on a
Coloured stuff-
ing may bleed
regular basis
can prolong
through the fabric
.
carpet life
when it becomes
Tip:
Before turning off the
Little Green, vacuum up
clean water to thoroughly
rinse out the interior of the
Vacuum Flex Hose. Then,
lift the cleaning tool and
point it upwards to drain any
remaining water into the Dirty/
Collection Tank.
3
Retainer Lever
1 - 8 0 0 - 2 6 3 - 2 5 3 5

Publicité

loading

Ce manuel est également adapté pour:

Little green 1425 serie