Electrodes Adjustment Diagram - Fan Assembly Diagram - Use Of The Burner - baltur BTG 15ME Mode D'emploi

BTG 15ME - BTG 20ME - BTG 28ME ELECTRODES ADJUSTMENT DIAGRAM
FAN ASSEMBLY DIAGRAM
USE OF THE BURNER
The burner operates fully automati-
cally, therefore it is non necessary
to carry out any kind at adjustment
- Observe the measurements indicated in the diagram
when fitting the fan.
during its operating. The "block" po-
sition is a safety position reached by
the burner automatically when some
of the components of the burners or
the plant do not work properly. It is
necessary to check then whether the
cause to the problem is a dangerous
one before unblocking the burner.
The causes to the block may be
temporary, for example when air
in inside the pipes. When it is un-
blocked, the burner starts operating
properly.
36 / 68
000608220_2007/03
 Ionisation electrode
2 Ignition electrode
3 Flame disk
4 Gas diffuser
5 Gas delivery pipe
A B
BTG 15ME 79 2
BTG 20ME 5 2÷3
BTG 28ME 5 2÷3
N° 0002934540
Rev.04/04/2005
If the burner stops three or four times
at a stretch, it is necessary either
to loock for the problem and solve
it or ask for the intervention of the
after sales service.The burner can
remain in the "block" position without
any limit in time. In emergency ca-
ses it is advisable to close the fuel
valve, and to disconnect the burner
electrically.
C
-
8,5
5