Dolmar AT3725A Manuel D'instructions page 23

Main power switch
Tap the main power button to turn on the tool.
To turn off the tool, press and hold the main power but-
ton until the power lamp and speed indicator go off.
► Fig.7: 1. Speed indicator 2. Main power button
3. Power lamp
NOTE: The tool will automatically turned off if it is left
without any operations for a certain period of time.
Switch action
WARNING:
For your safety, this tool is
equipped with lock-off lever which prevents the
tool from unintended starting. NEVER use the tool
if it runs when you simply pull the switch trigger
without pressing the lock-off lever. Return the
tool to our authorized service center for proper
repairs BEFORE further usage.
WARNING:
NEVER tape down or defeat pur-
pose and function of lock-off lever.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released. Operating a tool
with a switch that does not actuate properly can lead
to loss of control and serious personal injury.
Never put your finger on the main
CAUTION:
power button and switch trigger when carrying
the tool. The tool may start unintentionally and cause
injury.
NOTICE:
Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
The tool speed increases by increasing pressure on the
switch trigger. Release the switch trigger to stop.
AT3725A
► Fig.8: 1. Lock-off lever 2. Switch trigger
AT3725L
► Fig.9: 1. Lock-off lever 2. Switch trigger
Speed adjusting
You can adjust the tool speed by tapping the main
power button. Each time you tap the main power button,
the level of speed will change.
► Fig.10: 1. Speed indicator 2. Main power button
Speed indicator
Automatic Torque Drive Technology
When you turn on the Automatic Torque Drive
Technology (ADT), the tool runs at optimum rotation
speed and torque for the condition of grass being cut.
To start ADT, press and hold the reverse button until the
ADT indicator turns on. After that, tap the main power
button to select the cutting tool attached to the tool.
Light the lamp beside
and plastic blade,
head.
To stop ADT, press and hold the reverse button until the
ADT indicator turns off.
► Fig.11: 1.
indicator 4. Main power button 5. Reverse
button
Indicator
(Cutter blade)
(Nylon cutting
Reverse button for debris removal
WARNING:
the battery cartridge before you remove entan-
gled weeds or debris which the reverse rotation
function can not remove. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
23 ENGLISH
Mode Rotation speed
High 6,500 min
Medium 5,300 min
Low 3,500 min
marking to select cutter blade
marking to select nylon cutting
marking 2. marking 3. ADT
Mode Cutting tool
ADT Cutter blade
Plastic blade
ADT Nylon cutting
head
head)
Switch off the tool and remove
-1
-1
-1
Rotation
speed
3,500 - 6,500
-1
min
3,500 - 6,500
-1
min