BOMANN DU 7608 Mode D'emploi page 46

 Remove the grease filter(s).
(a) or (b):
Open the black protective box of the
plug-in device and release the plug connection.
 Carefully push the lamp out of the holder through
the housing.
 Replace defect LED module and connect the two
ends of the plug-in device.
 Insert new lamp properly in the bulb holder.
 Close the protective box with inserted plug-in
device. Replace the grease filter(s).
Troubleshooting
Before you contact an authorized specialist
Problem Possible Cause / Solution
Unit is not
- Check the power supply.
working or
- Check the power level.
not properly
Unit is not
- Check the power level.
working
- Is the kitchen properly ventilat-
efficiently
ed?
- Clean the grease filter(s).
- At recirculation mode, check the
carbon filter.
- Check the air outlet.
Light is not
- Check the bulb, see
working the bulb".
Oil is drip-
- Clean the grease filter(s).
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
Depending on model
"Replacing
Technical Data
Electrical connection............................................
Connection voltage: ..................220-240 V~ / 50 Hz
Connection power: ........................................67 W
Lighting, LED: .......................................1 x 2.0 W
Protection class: ...............................................I
Weight / Dimension in mm.....................................
Net weight: .....................................approx. 7.0 kg
Available accessory............................................
Activated carbon filter for recirculation mode: ...........
KF 563 (Art.-No. 256 300)
The right to make technical and design modifications
during continuous product development remains
reserved.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
compatibility and low voltage directives, and has
been constructed in accordance with the latest safety
regulations.
46
not supplied