Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION/SAFETY INFORMATION
DESCRIPTION
The Pentair Hydromatic® Basin Packages with easy out is ideal for
basement installations, pumping below-grade toilets, and laundry
facilities. It includes a submersible sewage pump and a premium
heavy duty structural foam, corrosion resistant sump/sewage basin
and lid for easy installation.
This submersible pump is designed for effluent and wastewater
removal, sump drainage, dewatering and flood control. The pump
has built in thermal overload protection and an automatic reset. The
mechanical seal and bearings on the motor shaft are permanently
lubricated. Stainless steel hardware and a heavy duty lift out handle
allow for easy disassembly after extended use.
The basin is used for residential, commercial, and industrial collection
of sewage, effluent drainage and seepage water. The basin cover
kit includes an inlet hub, a gas tight cover, cord seals, gaskets, and
hardware. No special tools or sealants are required.
NOTICE: This unit is not designed for applications involving salt water
or brine. Use with salt water or brine will void warranty.
SAFETY INFORMATION
Carefully read and follow all safety instructions in this manual
or on pump.
This is the safety alert symbol. When you see this symbol on your
pump or in this manual, look for one of the following signal words and
be alert to the potential for personal injury.
warns about hazards that will cause serious personal
injury, death or major property damage if ignored.
warns about hazards that can cause serious personal
injury, death or major property damage if ignored.
warns about hazards that will or can cause minor
personal injury or property damage if ignored.
The label NOTICE indicates special instructions which are important
but not related to hazards.
1. Read these rules and instructions carefully. Failure to follow them
could cause serious bodily injury and/or property damage.
2. Check your local codes before installing. You must comply with
their rules.
Hazardous voltage. Can shock, burn, or kill. During
operation the pump is in water.To avoid fatal shocks, proceed as
follows if pump needs servicing:
Risk of electrical shock.
Can burn or kill.
Do not lift pump by power
cord.
W-03-497 (04-20-20)
3. Disconnect power to outlet box before unplugging pump.
A.
B.
4. Do not run the pump dry. Dry running can overheat the pump,
(causing burns to anyone handling it) and will void the warranty.
5. The pump normally runs hot. To avoid burns when servicing pump,
allow it to cool for 20 minutes after shut-down before handling it.
6. The pump is permanently lubricated. No oiling or greasing is
required in normal operation. for overhaul, see instructions under
"Service".
7. Vent sewage or septic tank according to local codes.
8. Do not install the basin or pump in any location classified as
hazardous by the United States National Electrical Code (NEC), or
by the Canadian Electrical Code (CEC), where applicable.
California Proposition 65 Warning
known to the State of California to cause cancer, birth defects or
other reproductive harm.
CORD LIFT WARNING
1. Attempting to lift or support pump by power cord can damage cord
2. Cord may pull apart, exposing bare wires with possibility of fire or
3. Lifting or supporting pump by power cord will void warranty.
4. Use lifting ring or handle on top of pump for all lifting/lowering of
Take extreme care when changing fuses. Do not stand in
water or put your finger in the fuse socket.
Do not modify the cord and plug. When using the cord and
plug, plug into a grounded outlet only. When wiring to a system
control, connect the pump ground lead to the system ground.
This product and related accessories contain chemicals
and cord connections.
electrical shock.
pump. Disconnect power to pump before doing any work on pump
or attempting to remove pump from sump.
3
Publicité
