LUND Interceptor Instructions D'installation page 2

Installation Steps
3
Center hood shield on hood. Note the location where
the brackets will align with hood edge and mark with a
grease pencil. Remove hood shield.
4
Expose 2" (5 cm) of tape liner from each end of the center flanges
on the hood shield. Ensure that free ends of tape liner are acces-
Free end
6
Slide each bracket over hood edge, ensuring that it is centered on
the protective film previously installed in Step 5. Carefully close
hood.
protective film
8
NOTE: Actual application may vary slightly from illustrations.
Install (2) brackets on OUTBOARD hood shield flanges using machine screw and black washer.
sible.
Free end
bracket
screw
washer
hood shield
bracket
Center a piece of protective film over each grease pencil
mark, and wrap protective film around the hood edge at
5
Position hood shield back in place on hood.
7
9
Page 2 of 3
both locations.
Carefully close hood.