I N S TA L L AT I O N
5.
Feed Modular Emitter cable through the center of the heatsink and connect to
power supply.
6.
Fasten Modular Emitter to the heatsink with four of the included T10 Torx
screws. Screws should be hand-tight only, DO NOT OVERTIGHTEN.
7.
Insert power supply into docking station and ensure all wiring connections
are secure.
8.
Return the Light Engine to the desired tilt and rotation positions, lock in
place using red tilt lock and rotation lock levers.
P/N 3662821 Rev A
D3 MODULAR EMITTER INSTALLATION GUIDE | 5