Toolland TM 76006 Mode D'emploi page 10

TM 76006

Insert the drill or the screw bit in the
chuck.

Fasten the chuck by hand.

Fasten the chuck firmly by inserting the
chuck key in one of the holes in the side
of the chuck and turning it clockwise.

In order to remove a drill or screw bit,
you proceed in reverse order.
Before inserting or removing a drill
or screw bit always pull the plug
from the wall socket.
MOUNTING THE SIDE GRIP

Loosen the side grip

Slide the side grip over the chuck and
onto the machine.

Turn the side grip into the required
position and tighten it firmly.
MOUNTING THE DEPTH STOP
The depth stop is used to limit the maximum
drilling depth.

Loosen the side grip.

Insert the depth stop into the hole in the
side grip.

Set the depth stop to the required drilling
depth.

Tighten the side grip firmly.
SELECTING THE OPERATING MODE
Select the required operating mode before
use (drilling or hammer drilling).

For drilling in wood, metal, plastics and
soft stone and for driving screws, turn
the drill symbol on the switch to the
arrow.

For drilling in masonry, turn the hammer
and drill symbol on the switch to the
arrow.
Always wait until the motor has
come to a complete standstill
before changing the operating
mode.
FORWARD/REVERSE SWITCH

Push the forward/reverse switch to the
left to drill holes and fasten screws.

Push the forward/reverse switch to the
right loosens screws.
www.toolland.eu
Always wait until the motor has
come to a complete standstill
before changing the direction of
rotation.
ADJUSTING THE SPEED
This machine has been fitted with an
adjusting wheel for the maximum speed.

Turn the adjusting wheel as indicated on
switch to set the maximum speed.
SWITCHING ON AND OFF

To switch the machine on, press the
on/off switch. The further you press the
switch, the higher the speed of the
machine.

To switch off the machine, release the
on/off switch.

To switch the machine to continuous
mode, keep the on/off switch pressed and
at the same time press the lock-on/off
switch.

To switch off continuous mode, press the
on/off switch again.
TECHNICAL SPECIFICATIONS
Voltage
Frequency
Power
Speed (under load)
Drilling capacity
Wood
Steel
Concrete
Weight
Level of sound pressure measured according
to EN-standards:
Lpa (sound pressure)
Lwa (acoustic power)
WARANTY
Refer to the enclosed warranty conditions for
the terms and conditions of warranty.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.
English
230V
50Hz
500W
3000t/min
22mm
8mm
13mm
1,8kg
93,2dB(A)
K=3dB(A)
104,2dB(A)
K=3dB(A)
10