Publicité
Les langues disponibles
Les langues disponibles
1. Turn the locking ring anticlockwise and lift the filter straight up.
2. Empty and clean the filter.
3. Refit the filter and turn the locking ring clockwise to its stop position. Check that the edges seal
properly.
NOTE!
Dishwashing results may be affected if the filter is fitted incorrectly. The dishwasher must not be
used without the filter in place!
Cleaning the spray arms
Holes and bearings can sometimes become blocked. Remove any debris using a pin or the like.
The spray arms also have holes underneath.
To facilitate cleaning you can remove the spray arms. Remember to fit them firmly back into place
afterwards.
Upper spray arm
Pull out the upper basket.
Unscrew the spray arm bearings anticlockwise to remove the spray arm from the upper basket.
Check that the yellow
drainage pump stop on the
right in the bottom drain is in
place.
Care and cleaning
21
Publicité
