RAWLINK 78884 Manuel D'instructions page 14

AXLE STAND, 2,000 KG
Maximum load:
2,000 kg
Introduction
To get the most out of your new axle stand,
please read through these instructions
before use. Please also save the instructions
in case you need to refer to them at a later
date.
Technical data
Capacity:
Min. height:
Max. height:
Special safety instructions
Read and understand all warnings and
instructions before use.
Follow the axle stand's rated capacity. Do not
overload.
Please check every time prior to use that the
axle stands are not damaged or cracked and
that the welding joints are intact.
Check that the upright can be pulled all the
way to the top.
If there are signs of defects, the axle stand
must be discarded.
You must never attempt to repair a damaged
axle stand.
14
All manuals and user guides at all-guides.com
max. 2,000 kg
min. 280 mm
420 mm
Do not modify the axle stand's structure or
operation in any way.
Set the axle stand in place on a level and
permanent base, which can bear both the
weight of the axle stand and that of the car.
Do not operate the axle stand on inclined or
uneven surfaces.
A car must always be supported by 2, and
only 2, axle stands. Leave the hydraulic jack
in place under the car for safety's sake.
Lift only on the vehicle's lifting points as
speci� ed by the vehicle manufacturer.
Please make sure that you position the axle
stands in such a way that the car's lift points
are resting in a centered position on the load
bearing surfaces.
Where one end/side of the car is supported
by axle stands, you must not lift the other
end/side with a hydraulic jack.
Axle stands must not be used to support two
or three wheeled vehicles or trailers.
Never sit in the car and never start the car
whilst one side/end of the car is supported
by the axle stands.
NB! Always ensure that you have secured
the axle stands with the locking split pins.
The axle stands must not be used unless the
locking split pins are � tted.