Publicité
2.0 OPERATION
2.1
LIGHTING INSTRUCTIONS - for Intermittent Pilot
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
A.
This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.
BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbour's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a
qualified service technician. Force or attempted repair may result in a fire or explosion.
D.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace
any part of the control system and any gas control which has been under water.
1.
STOP! Read the safety information above on this label.
2.
Set the thermostat to the lowest setting.
3.
Turn off all electric power to the appliance.
4.
Do not attempt to light the pilot by hand.
5.
Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow "B" in the safety
information above on this label. If you don't smell gas, go to the next step.
6.
Turn on all electric power to the appliance.
7.
Set thermostat to desired setting (or switch to "ON" if not using a thermostat).
8.
If the appliance will not operate, follow the instructions "To Turn Off Gas To Appliance" and call your service technician or gas supplier.
1.Set thermostat to lowest setting.
2.Turn on/off switch to off.
FOR YOUR SAFETY, READ BEFORE LIGHTING
damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
TO TURN GAS OFF TO APPLIANCE
1. Pressure Taps
2. Main Valve Connection
3. Pilot Internal Solenoid Connection
4. Outlet Ports
5. Mounting Holes
7. Flow Control Screw
8. Pilot Connections
9. High/Low Connection
10. Inlet Ports
Page 13 of 54
Publicité
