Publicité
Les langues disponibles
Les langues disponibles
DECORATIVE TRIMMING
Decorative trimming is accomplished by removing all
vegetation around trees, posts, fences and more.
Rotate the whole unit so that the cutting attachment is at
a 30° angle to the ground (Fig. 28).
YM26BC ONLY:
USING THE CUTTING BLADE
WARNING:
protection and the shoulder strap to reduce the
risk of injury when operating this unit.
WARNING:
edging or as an edger. Severe personal injury
to yourself or others can result.
Before operating the unit with the cutting blade, stand in
the operating position (Fig. 29). Refer to Holding the
Trimmer.
Cutting Blade Operating Tips
To establish a rhythmic cutting procedure:
• Plant feet firmly, comfortably apart.
• Bring the engine to full throttle before entering the
material to be cut. At full throttle the blade has
maximum cutting power and is less likely to bind, stall
or cause blade thrust (which can result in serious
personal injury to the operator or others).
WARNING:
spinning blade contacts an object that it does
not immediately cut. Blade thrust can be violent
enough to cause the unit and/or operator to be
propelled in any direction, and possibly lose
control of the unit. Blade thrust can occur
without warning if the blade snags, stalls or
binds. This is more likely to occur in areas where
it is difficult to see the material being cut.
• Cut while swinging the upper part of your body from
left to right.
• Always release the throttle trigger and allow the engine
to return to idle speed when not cutting.
• When you are finished, always unsnap the unit from
the harness before taking off the harness.
16
OPERATING INSTRUCTIONS
Fig. 28
Always wear eye,
hearing, foot, body
Do not use the
cutting blade for
Bl ade thrust may
occur when the
WARNING:
engine is turned off. The coasting blade can
seriously cut you if accidentally touched.
• Swing the unit in the opposite direction as the blade
spins, which increases the cutting action.
• After the return swing, move forward to the next area
to be cut plant your feet again.
• The cutting blade is designed with a second cutting
edge. You can use it by removing the blade, turning it
upside down, and reinstalling it.
WARNING:
Sharpening the blade can cause the blade tip
to break off while in use. This can result in
severe personal injury to yourself or others.
Replace the blade.
To reduce the chance of material wrapping around the
blade, follow these steps:
• Cut at full throttle
• Swing the unit into material to be cut from your left to
your right (Fig. 30)
• Avoid the material just cut as you make the return swing
WARNING:
the engine running or blade turning. To avoid
serious personal injury, turn off the engine.
Allow the blade to stop before removing
materials wrapped around the blade shaft.
The blade continues
to spin after the
Do not sharpen the
cutting blade.
Do not clear away
any cut material with
Fig. 29
Fig. 30
Publicité
