GE PFW950 Guide De L'utilisateur Et Instructions D'installation page 26

REVERSING THE DOOR SWING ( OPTIONAL ON SOME
MODELS ONLY )
REMOVE LOCK ASSEMBLY AND
7
INSTALL ON OPPOSITE SIDE OF
WASHER (CONTINUED)
• Remove the lock switch cover button from the back
of the lock cover plate and replace it in the opposite
hole in the lock cover plate.
NOTE: The cover button must be reinstalled into the
lower hole in the lock cover plate as shown.
Lock Cover Plate
Press the cover button out,
from front-to-back,
to remove it
Rotate the cover button,
from top-to-bottom, and
press it into the back of
the lower hole
• Install the lock cover plate over the lock assembly,
making sure that the lock switch operates freely.
Replace its screws.
Lock Cover Plate
Lock Switch
Cover button
in lower hole
26
Installation Instructions
Front Side View
RECONNECT PIN CONNECTOR
8
FROM THE WASHER AND REPLACE
THE TERMINAL HOLDER
• Reconnect the
pin connector and
press the terminal
holder back into
the washer face on
the opposite side.
Pin Connector
Terminal Holder
REPLACE THE DOOR ASSEMBLY
9
• Lift the door assembly into place and secure it onto
washer face with its 6 screws.
Replace this
screw first
Replace 6 screws
into the hinge and
secure into the
washer face
• Close the washer door.
NOTE: Make sure the door opens and closes
correctly. If not, repeat all steps making sure all
parts and screws are securely seated.
• Connect power cord and turn on the breaker.
• Run the washer through a complete cycle to verify
proper operation.
49-3000217 Rev 6