Wiring Details; Terminal Assignment - WIKA intelliGAUGE PGT23.063 Mode D'emploi

7. Wiring details

7. Wiring details
Electrical connection of this pressure transmitter is made via an L-plug connec-
GB
tor. Precise wiring diagrams can be found in the following drawings. In addition
to the wiring details, output signal and required power supply are given on the
rating plate.
Description of terminal designations used:
U + Plus terminal for supply voltage
B
0 V Minus terminal for supply voltage
Sig+ Plus terminal for output signal
Sig- Minus terminal for output signal
The instruments must be included within the plant's equipotential bonding


Terminal assignment

Terminals 1 and  are the terminals for the signal output and for the power
supply. The terminal marked with PE (protective earth) is connected internally
to the housing. The connections  to 6 or 4 to 6 (for the -wire version), must
remain free and must not be used as connection points (also see Chapter 10
"Technical data").
2-wire design
i.e. 4 ... 20 mA
ground, bonded/
connected to case
Power supply
Evaluation
(display/recorder)
An unstabilised DC voltage, with a residual ripple of max. 10 % peak-to-peak in
the range of the indicated supply voltage limits, is sufficient as a power supply.
Make sure that the supply voltage applied exceeds the maximum required
voltage by at least the value of the voltage drop across the external display
or evaluation devices; i.e. the transmitter can operate using a non-stabilised
supply voltage within the given limits, so long as the voltage available to the
transmitter does not fall below 1 V, or below 14 V for the Ex-version.
Connection details (only model PGT23.063)
Cable
red
black
brown
- - -
14
Connector housing
U +/Sig+
B
+0V/Sig-
Terminals 3, 4, 5 and 6:
only for internal use
Plug connector
Pin 1
Pin 4
Pin 
Pin 
3-wire design
i.e. 0 ... 20 mA / 0 ... 10 V
Power supply
Evaluation
(display/recorder)
Meaning
U +/Sig +
B
0 V/Sig -
n.c.
n.c
WIKA Operating Instructions intelliGAUGE family
ground, bonded/
connected to case
U +/Sig+
B
I /U
out out
+0V/Sig-
Terminals 4, 5 and 6:
only for internal use