Publicité
2.2 Unpacking your refrigerator
Remove tape and any labels from your refrigerator before using (except the
rating label).
To remove any remaining tape or glue, rub the area briskly with your thumb.
Tape or glue residue can also be easily removed by rubbing a small amount
of liquid dish soap over the adhesive with your fingers. Wipe with warm
water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your refrigerator.
When moving the refrigerator, do not tilt the refrigerator beyond 45°from
upright position.
2.3 Cleaning before use
After you remove all of the packaging materials, (especially the foam
between outside condenser and cabinet should be removed ）clean the
inside of your refrigerator before using it.
2.4 Space requirements
¡WARNING! Keep flammable materials and vapors, such a s gasoline,
away form refrigerator. Failure to do so can result in death, explosion, fine
or burns.
To ensure proper ventilation for your refrigerator, allow for 200mm space
on each side between walls, 200mm space between back of your
refrigerator and the wall, and 300mm space between counter top and the
roof or ceiling.
If you are installing your refrigerator next to a fixed wall, leave sufficient
space on the hinge side to allow for the door to wing open.
Never install your refrigerator near heat source and direct sun shine.
2.5 Electrical Requirement
¡
WARNING!:
Do not remove ground prong.
Do not use an adaptor.
15
V.3
Publicité
