Hilti TE 2 Notice D'utilisation Originale page 14

Trouble or fault
No hammering action.
The rotary hammer doesn't
achieve full power.
The drill bit cannot be re-
leased.
The drill bit makes no
progress.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Notice d'utilisation originale
1 Indications relatives au mode d'emploi
1.1 À propos de ce mode d'emploi
• Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
1.2 Explication des symboles
1.2.1 Avertissements
Les avertissements attirent l'attention sur des dangers liés à l'utilisation du produit.
signalisation suivants sont utilisés :
DANGER
DANGER !
▶ Pour un danger imminent qui peut entraîner de graves blessures corporelles ou la mort.
8 Français
Possible cause
The function selector switch is set
to "Rotary drilling only"
The control switch is not fully
pressed.
TE 2-S
Function selector switch set to
"Light hammering action"
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The chuck is not pulled back fully.
The power tool has been set to
reverse rotation.
Action to be taken
▶ Set the function selector switch
. to the "Hammer drilling" position
.
▶ Press the control switch as far
as it will go.
▶ Set the function selector switch
to the "Hammer drilling" position
.
.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Pull the tool lock back as far as
it will go and remove the tool.
▶ Set the power tool to forward
rotation.
228074
*228074*
C'est la condition
Les termes de