Lea LE24100DP Mode D'emploi page 16

Only use the type of cutting line recommended by the manufacturer. Never use a metal
cutting line or fishing line.
Remove the plug from the wall socket when you have finished, before servicing, or when
the appliance is not being used.
After use, always store the appliance safely and out of the reach of children.
Do not cut against hard objects. This could cause injury or damage the trimmer.
Do not use the trimmer to cut grass which is not in contact with the ground, for example,
do not cut grass which is on walls or rocks etc.
7. ASSEMBLY
The trimmer is supplied with some components which need to be assembled. Please proceed
as follows:
7.1 Safety guard assembly
Attacht the safety guard with the screws applied.
-
7.2 Auxiliary handle assembly (Fig.3.1/Fig.3.2)
Attach the auxiliary handle to the support.
-
Rotate the lock button to tighten the auxiliary handle.
-
7.3 Tube assembly(Fig.4.1/Fig.4.2)
Insert the tube into the hole.
-
Rotate the lock button to tighten the tube.
-
7.4 Changing the nylon wire(Fig.5.1~Fig.5.9)
8. OPERATION
8.1 Starting
To switch on the trimmer first press the On/Off trigger (3). To switch off simply release the
-
On/Off switch trigger(3)
If you find that the nylon line is too short, let the trimmer run for a few seconds without
-
touching the working area to allow the trimmer to cut the line after it lengthens.
Do not overload the trimmer, cut in small sections which will greatly improve efficiency by
-
keeping the trimmer running at high speed,
9. TROUBLE SHOOTING
PROBLEM
Line will not
advance
Cutting head is
hard to turn
Grass
( )
Fig.2.1~Fig.2.3
POSSIBLE CAUSE
Line is welded to itself
Not enough line on the spool
Line has worn too short
Line is tangled on the spool
Grass wrapped or built up
around head
Cutting tall grass at ground
13
SOLUTION
Lubricate with a silicone
spray
Replace the spool
Remove the spool and
feed line out
Remove line from spool
and rewind
Clean the effected parts
of the machine
Cut tall grass from the top