Maintenance; Scheduled Maintenance Table - Nilfisk RS 1300 Manuel D'utilisation

Masquer les pouces Voir aussi pour RS 1300:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed when the machine is off (ignition key removed).
Moreover, read carefully the instructions in Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Center.
This Manual contains the Scheduled Maintenance Table and describes only the easiest and most common maintenance
procedures.
For other maintenance procedures contained in the Scheduled Maintenance Table or for extraordinary maintenance procedures see
the Service Manual that can be consulted at any Service Center.
For scheduled and extraordinary maintenance of the following optional equipments, refer to the relevant Manuals:
Salt spreader
Snow brush
Snow cutter
Camera kit

SCHEDULED MAINTENANCE TABLE

Maintenance
Engine oil level check
Hydraulic system oil level check
Engine air pre-fi lter and fi lter cleaning
Engine radiator fi n cleaning check
Engine coolant level check
Hydraulic system oil cooler fi n check
Battery fl uid level check
Hopper, fi lter and suction hose cleaning, gasket
check and fan bearing lubrication
Water nozzle and fi lter cleaning
Brake fl uid level check
Reverse gear buzzer operation check and sensor
adjustment
Diesel engine start-up safety system check
Engine fuel fi lter cleaning
Engine radiator fi n cleaning
Tyre pressure check
Suction inlet and skirt height and operation check
Side broom position check and adjustment
3rd broom position check and adjustment
Hopper and suction hose gasket wear check
Running-in
Every 10
period (after the
hours or
fi rst 50 hours)
before use
RS 1300
USER MANUAL
Every
Every
Every
150
300
hours
hours
hours
(8)
(1)
(1) (8)
(8)
33014091(3)2008-02 A
ENGLISH
Every
Every
500
1,000
2,000
hours
hours
33

Publicité

Table des Matières
loading

Table des Matières