Publicité
Les langues disponibles
Les langues disponibles
A
NSWERER
Problem
Doesn't answer, or answers on 10th ring.
Incoming messages are incomplete.
Won't respond to remote commands.
Answerer doesn't work.
After the unit is plugged in, FLASH ERROR
is displayed
Explanation/Solution
• Make sure the answerer is turned on.
• Memory is full, erase some messages.
• Check the AC power and phone line
connections.
• Was an extension phone picked up?
• The caller left a message that is longer than the
message length you set during setup.
• Memory is full.
• Must use a touch-tone phone.
• Must enter the correct security code.
• Did unit hang up? If you take no action for a
period of time, it automatically hangs up.
• Unplug the power cord from the electrical
outlet and plug it back in to reset the answerer.
• Unplug the unit and plug it back in. If the
message appears again, the unit needs service.
43
Publicité
