Canon imagePROGRAF TZ-30000 Manuel D'installation page 7

6
Lowering the Printer from the Pallet
1
Use the slope pins to affix the two ramps that you
removed in "4. Removing the Ramps."
Note
● Since the ramps have the same shape, you can use either one on
the left and right sides.
● The ramp pins are packed in the bag that contains this manual.
● Push the ramp pins all the way in.
3
Unlock all four casters.
Important
● Since the printer may move when the casters are unlocked, hold
the printer in place.
2
Push the sheet into the hole in the side of the pallet.
Do not bend the sheet on the side where the ramps are
affixed, but leave it as-is.
Caution
● If the sheet is not pushed in, your feet may become entangled in
the sheet causing you to fall.
4
Check that the casters are on the ramps, and hold the
printer by the carrying grips and move it slowly in the
direction of the arrow to lower it down the ramps.
Caution
● Since it is a heavy object, this work should be performed as
slowly as possible by multiple people.
● When moving the printer, take care of where your feet are
placed to avoid the casters running over your feet.
5